Dual Control Potentiometer Dual Stacked Concentric Pots
(Please Read the Details)
Premium quality and long life dual control pots.
Typically found on Bass and some guitars.
Used to reduce the need for additional potentiometer slots and holes.
Each shaft controls the two independent potentiometers.
This can be used as 2 independent volume control or 1 volume, 1 tone control, and a lot more!
Perfect for guitar wiring electronics upgrade!
Specs:
- The mounting hole diameter should be at least 7.9mm
- Bushing height is 3/8” or 9.5mm
- Small (upper) shaft diameter is 5.8mm
- Big (lower) shaft diameter is 7.8mm
- Plain (Solid) shaft
- Solder Lugs with Center Detent
- PC Pins No Center Detent
Options available:
Linear Taper - B50k (with center detent)
Linear Taper - B50k PC Pins (no center detent)
Linear Taper - B100k (with center detent)
Linear Taper - B250k (with center detent)
Linear Taper - B500k (with center detent)
Includes:
1 potentiometer
2 hex Nuts and Washers
1 washer
**********
We specialize in custom guitar wiring and handwound pickups.
Please let us know if you have questions or clarification.
You can also check our website for more wiring guide info.
Feel free to send a message and we will reply asap.
Thank you!
Dual Control Potentiometer
Options
Value
Will it fit my guitar?
Fit values for this pot are stored in four product fields (fit, thread, mounting, shaft). If a product has no values, this checker hides itself.
Knobs that fit this pot
Matched to split, 18 splines (coarse).



Technical specifications
| Value | B100k, B250k, B500k, B50k |
| Fits | Asian / metric guitars |
| Thread | 8mm bushing · 3/8" (9.5mm) standard length |
| Mounting | Wood top, body, or pickguard |
| Shaft | Split, 18 splines (Coarse) |
| Brand | Montances Guitar Wiring |
US vs Asian pots
US pots (CTS and similar) usually have a 3/8″ (9.5mm) bushing and fine 24-spline shafts.
Asian or metric pots (Alpha, many Bourns) usually have an 8mm bushing and coarse 18-spline shafts.
A metric pot drops loosely into a US hole. A US pot will not fit a metric hole without enlarging it.
Knobs must match the spline count. Forcing the wrong one can break the shaft.